GIF89a;
Direktori : /lib/modules/3.10.0-957.21.3.el7.centos.plus.x86_64/source/drivers/net/ethernet/sfc/ |
Current File : //lib/modules/3.10.0-957.21.3.el7.centos.plus.x86_64/source/drivers/net/ethernet/sfc/Kconfig |
# # Solarflare device configuration # config NET_VENDOR_SOLARFLARE bool "Solarflare devices" default y ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the questions about Solarflare devices. If you say Y, you will be asked for your specific card in the following questions. if NET_VENDOR_SOLARFLARE config SFC tristate "Solarflare SFC9000/SFC9100-family support" depends on PCI select MDIO select CRC32 select I2C select I2C_ALGOBIT select PTP_1588_CLOCK ---help--- This driver supports 10/40-gigabit Ethernet cards based on the Solarflare SFC9000-family and SFC9100-family controllers. To compile this driver as a module, choose M here. The module will be called sfc. config SFC_MTD bool "Solarflare SFC9000/SFC9100-family MTD support" depends on SFC && MTD && !(SFC=y && MTD=m) default y ---help--- This exposes the on-board flash and/or EEPROM as MTD devices (e.g. /dev/mtd1). This is required to update the firmware or the boot configuration under Linux. config SFC_MCDI_MON bool "Solarflare SFC9000/SFC9100-family hwmon support" depends on SFC && HWMON && !(SFC=y && HWMON=m) default y ---help--- This exposes the on-board firmware-managed sensors as a hardware monitor device. config SFC_SRIOV bool "Solarflare SFC9000-family SR-IOV support" depends on SFC && PCI_IOV default y ---help--- This enables support for the SFC9000 I/O Virtualization features, allowing accelerated network performance in virtualized environments. config SFC_MCDI_LOGGING bool "Solarflare SFC9000/SFC9100-family MCDI logging support" depends on SFC default y ---help--- This enables support for tracing of MCDI (Management-Controller-to- Driver-Interface) commands and responses, allowing debugging of driver/firmware interaction. The tracing is actually enabled by a sysfs file 'mcdi_logging' under the PCI device. source "drivers/net/ethernet/sfc/falcon/Kconfig" endif # NET_VENDOR_SOLARFLARE