Current File : //lib/modules/3.10.0-957.21.3.el7.centos.plus.x86_64/source/drivers/net/ethernet/micrel/Kconfig
#
# Micrel device configuration
#
config NET_VENDOR_MICREL
bool "Micrel devices"
default y
depends on (HAS_IOMEM && DMA_ENGINE) || SPI || PCI || HAS_IOMEM || \
(ARM && ARCH_KS8695)
---help---
If you have a network (Ethernet) card belonging to this class, say Y
and read the Ethernet-HOWTO, available from
<http://www.tldp.org/docs.html#howto>.
Note that the answer to this question doesn't directly affect the
kernel: saying N will just cause the configurator to skip all
the questions about Micrel devices. If you say Y, you will be asked
for your specific card in the following questions.
if NET_VENDOR_MICREL
config ARM_KS8695_ETHER
tristate "KS8695 Ethernet support"
depends on ARM && ARCH_KS8695
select NET_CORE
select MII
---help---
If you wish to compile a kernel for the KS8695 and want to
use the internal ethernet then you should answer Y to this.
config KS8842
tristate "Micrel KSZ8841/42 with generic bus interface"
depends on HAS_IOMEM && DMA_ENGINE
---help---
This platform driver is for KSZ8841(1-port) / KS8842(2-port)
ethernet switch chip (managed, VLAN, QoS) from Micrel or
Timberdale(FPGA).
config KS8851
tristate "Micrel KS8851 SPI"
depends on SPI
select NET_CORE
select MII
select CRC32
select EEPROM_93CX6
---help---
SPI driver for Micrel KS8851 SPI attached network chip.
config KS8851_MLL
tristate "Micrel KS8851 MLL"
depends on HAS_IOMEM
select NET_CORE
select MII
---help---
This platform driver is for Micrel KS8851 Address/data bus
multiplexed network chip.
config KSZ884X_PCI
tristate "Micrel KSZ8841/2 PCI"
depends on PCI
select NET_CORE
select MII
select CRC32
---help---
This PCI driver is for Micrel KSZ8841/KSZ8842 PCI Ethernet chip.
To compile this driver as a module, choose M here. The module
will be called ksz884x.
endif # NET_VENDOR_MICREL
Mini Shell