GIF89a;
Direktori : /lib/modules/3.10.0-1160.88.1.el7.centos.plus.x86_64/source/arch/blackfin/mach-bf537/ |
Current File : //lib/modules/3.10.0-1160.88.1.el7.centos.plus.x86_64/source/arch/blackfin/mach-bf537/Kconfig |
if (BF537 || BF534 || BF536) source "arch/blackfin/mach-bf537/boards/Kconfig" menu "BF537 Specific Configuration" comment "Interrupt Priority Assignment" menu "Priority" config IRQ_PLL_WAKEUP int "IRQ_PLL_WAKEUP" default 7 config IRQ_DMA_ERROR int "IRQ_DMA_ERROR Generic" default 7 config IRQ_ERROR int "IRQ_ERROR: PPI CAN MAC SPORT0 SPORT1 SPI UART0 UART1" default 11 config IRQ_RTC int "IRQ_RTC" default 8 config IRQ_PPI int "IRQ_PPI" default 8 config IRQ_SPORT0_RX int "IRQ_SPORT0_RX" default 9 config IRQ_SPORT0_TX int "IRQ_SPORT0_TX" default 9 config IRQ_SPORT1_RX int "IRQ_SPORT1_RX" default 9 config IRQ_SPORT1_TX int "IRQ_SPORT1_TX" default 9 config IRQ_TWI int "IRQ_TWI" default 10 config IRQ_SPI int "IRQ_SPI" default 10 config IRQ_UART0_RX int "IRQ_UART0_RX" default 10 config IRQ_UART0_TX int "IRQ_UART0_TX" default 10 config IRQ_UART1_RX int "IRQ_UART1_RX" default 10 config IRQ_UART1_TX int "IRQ_UART1_TX" default 10 config IRQ_CAN_RX int "IRQ_CAN_RX" default 11 config IRQ_CAN_TX int "IRQ_CAN_TX" default 11 config IRQ_MAC_RX int "IRQ_MAC_RX" default 11 config IRQ_MAC_TX int "IRQ_MAC_TX" default 11 config IRQ_TIMER0 int "IRQ_TIMER0" default 7 if TICKSOURCE_GPTMR0 default 8 config IRQ_TIMER1 int "IRQ_TIMER1" default 12 config IRQ_TIMER2 int "IRQ_TIMER2" default 12 config IRQ_TIMER3 int "IRQ_TIMER3" default 12 config IRQ_TIMER4 int "IRQ_TIMER4" default 12 config IRQ_TIMER5 int "IRQ_TIMER5" default 12 config IRQ_TIMER6 int "IRQ_TIMER6" default 12 config IRQ_TIMER7 int "IRQ_TIMER7" default 12 config IRQ_PROG_INTA int "IRQ_PROG_INTA" default 12 config IRQ_PORTG_INTB int "IRQ_PORTG_INTB" default 12 config IRQ_MEM_DMA0 int "IRQ_MEM_DMA0" default 13 config IRQ_MEM_DMA1 int "IRQ_MEM_DMA1" default 13 config IRQ_WATCH int "IRQ_WATCH" default 13 help Enter the priority numbers between 7-13 ONLY. Others are Reserved. This applies to all the above. It is not recommended to assign the highest priority number 7 to UART or any other device. endmenu endmenu endif