Current File : //lib/modules/3.10.0-1160.81.1.el7.centos.plus.x86_64/build/drivers/extcon/Kconfig
menuconfig EXTCON
tristate "External Connector Class (extcon) support"
help
Say Y here to enable external connector class (extcon) support.
This allows monitoring external connectors by userspace
via sysfs and uevent and supports external connectors with
multiple states; i.e., an extcon that may have multiple
cables attached. For example, an external connector of a device
may be used to connect an HDMI cable and a AC adaptor, and to
host USB ports. Many of 30-pin connectors including PDMI are
also good examples.
if EXTCON
comment "Extcon Device Drivers"
config EXTCON_GPIO
tristate "GPIO extcon support"
depends on GPIOLIB
help
Say Y here to enable GPIO based extcon support. Note that GPIO
extcon supports single state per extcon instance.
config EXTCON_ADC_JACK
tristate "ADC Jack extcon support"
depends on IIO
help
Say Y here to enable extcon device driver based on ADC values.
config EXTCON_MAX77693
tristate "MAX77693 EXTCON Support"
depends on MFD_MAX77693 && INPUT
select IRQ_DOMAIN
select REGMAP_I2C
help
If you say yes here you get support for the MUIC device of
Maxim MAX77693 PMIC. The MAX77693 MUIC is a USB port accessory
detector and switch.
config EXTCON_MAX8997
tristate "MAX8997 EXTCON Support"
depends on MFD_MAX8997 && IRQ_DOMAIN
help
If you say yes here you get support for the MUIC device of
Maxim MAX8997 PMIC. The MAX8997 MUIC is a USB port accessory
detector and switch.
config EXTCON_ARIZONA
tristate "Wolfson Arizona EXTCON support"
depends on MFD_ARIZONA && INPUT && SND_SOC
help
Say Y here to enable support for external accessory detection
with Wolfson Arizona devices. These are audio CODECs with
advanced audio accessory detection support.
endif # MULTISTATE_SWITCH
Mini Shell